Project

General

Profile

5.3.14. Settings of PID control loops

In the Application settings Device configuration -> PID control


Settings of PID control loops window

In this section, you can change the PID coefficients.
A voltage PID is used, K_p, K_i and K_d coefficients can vary in 0..65535 range for DC motors.

Fractional PID coefficients (on right) are only for BLDC motor (supported in firmware 4.1.x and older).

Warning. Do not change the settings of PID controllers, if you are not sure you know what you are doing!

Configuration commands are described in the Communication protocol specification. PID tuning is described in detail in the PID-algorithm for DC engine control section.

Add picture from clipboard (Maximum size: 977 MB)